How do I set up my actuators to make them work with Lince?

3Motion System example

• Navigate to Cockpit / Connection Configuration window.
  

• Here you can find:

1. Set system type. In this example we are going to setup a 3Motion type. Select 3Motion and set actuators models to Dyadic Hyperaxis [100mm].
2. Lince will detect automatically your serial actuators numbers and show them in the box Actuators Information (Number 2).
3. Just click over a serial number in Actuators information and then click over the Actuator box (Number 3). It’s a easy way to copy and paste the serial number. Id = 0 (if your actuators has another Id, set here) and Port = None.
4. You can do a quick test selecting the actuator by the grey button near the actuator info box and changing the number of the slider in the Test section (number 4).

If everything is detected and configured, the system will start up the actuators and set a central position. Please, press accept button.

• Now your system is ready to configure a profile for any game.

1. Information about your system (serial number, type, etc)
2. You can configure your actuator setting and the game effects.
3. Once you modify any profile, push diskette button to save the profile.

Recommendations

Actuators configuration:

• Start with low values (just to ensure the system is working properly). The parameter means the % of the maximum value applied to the actuator.
• G’s maximum is the value of G generated by the car that you are driving (Renault generate 1G, F1 generates 4G, so select a approximated value, 2 or 2.5 is a good starting value)

Effects configuration:

• The software represents the acceleration in any axes. So your simulation experience depends of these values. If any effect is inverted, please, set a opposite signal (for example, 80 -> -80)
• Smooth is a good value to change… Experiment with this! ?
• Vertical G’s represents all the vertical motion.

If you have any questions or query please open a ticket and we will help you.

Enjoy your races ?